- 1.8m USB to TTL serial adapter (with 6 pin 0.1” pitch female socket header) connects devices with 5V logic level UART signals interface to a laptop via USB port
- A genuine FT232RL chip module is housed in USB 2.0 type A male terminal for wider compatibility and supports reliable data transfer rates
- 1.8 meter FTDI USB to serial cable (6 way outputs, Single-In-Line ) provides access to Tx, Rx, RTS#, CTS#, VCC (5v) and GND
- FTDI chipset on the PCB board has configurable internal EEPROM and UART signals can be individually inverted by configuring the EEPROM
- Compatible with Windows 10, 8, 8.1, 7 (32, 64-bit), 2008/XP/Vista/CE, Mac OS, Linux 2.4 and greater; ideal USB 2.0 debug cord for Vendor ID re-write, router, GPS, set top box, transmitter, flash firmware on hard drive, etc.
1.8 meter short FT232RL FTDI USB to TTL serial adapter cable for 5V logic level serial communication
It is built with FTDI FT232 chip, FTDI’s royalty-free VCP allow for communication as a standard COM port and D2XX ‘direct’ drivers provide DLL application programming interface; a great conversion data cord to meet with your needs of debugging, boot-loading, programming, etc.
NOTE: If any installation or usage issues, please email us or you may download a driver and usage guide on FTDI official website
The original FTDI chip is embedded in the USB-A end; 6 way 0.1” header connector with VCC (5V power) and GND (ground), as well as RXD, TXD, RTS and CTS at 5 V logic level.
Applications:
Upgrading Legacy Peripherals to USB
Interface Microcontroller UART or I/O, FPGA / PLD to USB
Replace MAX232 type level shifters allowing for direct connection of products to PC
Industrial Control / USB Software / Hardware Encryption Dongles
Features
– The I/O pins of the FTDI wire are configured to operate at 5.0V logic level – Entire USB protocol handled by the electronics in the cable;
– UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity;
– Data transfer rates from 300 to 3M baud rate at TTL levels;
– Fully assisted hardware (RTS#/CTS#) or X-On / X-Off software handshaking;
– Internal EEPROM with users writable area; – Supply voltage comes from USB bus, no external supply required;
– UHCI / OHCI / EHCI host controller compatible
Specific Interfaces: USB 2.0 type A Male Port ; 6 pin Female Socket Header
Supports Windows 2008, XP and XP 64-bit, Vista and XP 64-bit, CE 4.2, 5.0 and 6.0; Windows 7, 8, 8.1, 10 (32 and 64-bit); Mac OS 8/9 , OS-X; Linux 2.4 and greater
What’s Included
1 x 1.8m USB to Serial TTL Level Converter Cable
1 X User Manual
Reviews
There are no reviews yet.